Custom roller brushes and sweeper brushes for robotic cleaning equipment used on floors, facades, hulls, greenhouse roofs, aircraft, wind turbines, and solar panels.
We manufacture the working brush component for cleaning robots and automated washing equipment where contact brushing is specified.
Brush diameter, working width, face pattern, filament, core, shaft, hub, and drive interface are reviewed against the equipment drawing or approved sample.
Main roller brushes collect loose debris, while side sweeper brushes clean along walls and edges. Brush diameter, working width, face pattern, hub, shaft, and drive interface can be customized.
Soft roller brushes clean approved glass, metal panels, and other facade surfaces. Working width, trim, density, water compatibility, and mounting can be matched to the machine.
Non-metallic roller brushes can be reviewed for proactive biofilm and light-fouling removal where contact cleaning is specified. Material and contact pattern must suit the robot design and approved hull coating.
Rotating roller and gutter brushes can clean approved glass or plastic-film greenhouse roofs. Brush profile, working width, filament, and contact stiffness are matched to the roof-washing equipment.
Large soft roller brushes can be made for wet or dry aircraft-washing systems. Filament, end treatment, working width, core, shaft, and balance follow the approved equipment drawing.
Custom rotating brushes can be reviewed for water-assisted turbine-cleaning equipment where contact brushing is specified. Brush size, material, pressure target, and mounting must match the contacted surface and machine design.
Soft roller brushes are produced for robotic and water-fed solar-panel cleaning systems. Filament, density, dimensions, and mounting are selected around the equipment and panel-contact requirements.
Nylon, PP, PBT, and other approved synthetic filaments.
Custom stiffness, trim, density, and face pattern.
Custom brush diameter and working width.
Custom core, shaft, hub, bore, keyway, and drive interface.
Surface, coating, liquid, chemical, speed, and pressure reviewed by application.
Sample review followed by repeat and volume manufacturing to the confirmed specification.
No. We manufacture custom roller-brush and sweeper-brush components, not motors, sensors, controls, navigation, vacuum systems, water systems, or complete robots.
Yes. Send a drawing or approved sample showing the finished dimensions, brush arrangement, and machine interface. Compatibility is confirmed from the supplied information rather than the machine name alone.
Selection depends on the surface or coating, wet or dry operation, chemicals, brush speed, contact pressure, and cleaning target. Final suitability should be validated in the customer’s equipment.
Sample approval can be reviewed before repeat and volume production to the confirmed drawing and specification.
Send a clear drawing or approved sample. We manufacture custom roller brushes and sweeper brushes for OEM, replacement, and repeat-volume programs.